kiranlaleu
Junior Member level 1
Hi all,
I would like to know if anyone here could help me with the above and point me to the correct method to calculate and design the snubber for the opto-coupler and triac in the following schematic as shown in the official datasheet. I would like to know how they arrive at the conclusion with those values when the load is non decided and is for a generalized application.
dv/dt information given in the data sheets were for temp 25deg celsius which seems so different from the real world operation.
I would like to the know the actual industrial practice of solving this issue.
I would like to know if anyone here could help me with the above and point me to the correct method to calculate and design the snubber for the opto-coupler and triac in the following schematic as shown in the official datasheet. I would like to know how they arrive at the conclusion with those values when the load is non decided and is for a generalized application.
dv/dt information given in the data sheets were for temp 25deg celsius which seems so different from the real world operation.
I would like to the know the actual industrial practice of solving this issue.