_SquiD_
Advanced Member level 4
cadence ic5033 install centos
I have this project to work on ... and I really need this app installed. I tried installing IC5033 on CentOS 5.1 for about a week now ... and still didn't succeed. First there was a problem in choosing the right linux distro ... and as far as I read on this forum ... I understood that Red Hat 8,9 and RHEL 5.0 are most suitable. When I've seen that most of them didn't accept SATA hard-drives I've installed CentOS 5.1 because I've understood that the libraries used for this distro are the same with RHEL.
After that I've tried installing CADENCE ... with IC5033 but I don't know if I'm doing it right. As a tutorial I chose a topic on this forum : . But at the 3rd step of this tutorial when I try to compile the certain file I get lots of warnings. The rest of the configuration goes well until the 7th step ... after choosing all the available packages ... the installation does nothing ... no new appeared in the destination folder.
Could anyone tell me where I've done wrong ? Is there a better tutorial ? Please give me some detailed advice ... noobie style I'd prefer.
Thanks in advance.
I have this project to work on ... and I really need this app installed. I tried installing IC5033 on CentOS 5.1 for about a week now ... and still didn't succeed. First there was a problem in choosing the right linux distro ... and as far as I read on this forum ... I understood that Red Hat 8,9 and RHEL 5.0 are most suitable. When I've seen that most of them didn't accept SATA hard-drives I've installed CentOS 5.1 because I've understood that the libraries used for this distro are the same with RHEL.
After that I've tried installing CADENCE ... with IC5033 but I don't know if I'm doing it right. As a tutorial I chose a topic on this forum : . But at the 3rd step of this tutorial when I try to compile the certain file I get lots of warnings. The rest of the configuration goes well until the 7th step ... after choosing all the available packages ... the installation does nothing ... no new appeared in the destination folder.
Could anyone tell me where I've done wrong ? Is there a better tutorial ? Please give me some detailed advice ... noobie style I'd prefer.
Thanks in advance.