drmius
Newbie level 6
Hello all
I am trying to download program from laptop to my Atmega16. For this purpose I am using USBASP. The datasheet for the USBASP I am using is attached below. I followed the pinout and driver installation according to the manual. However, when I try to transsfer code I get following error:
avrdude: warning: cannot set sck period. please check for usbasp firmware update.
avrdude: error: programm enable: target doesn't answer. 1
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
avrdude done. Thank you.
Assuming it is micro-controller error I bought a new IC but the problem persist. Please let me know how to proceed further
Regards
Srinidhi
I am trying to download program from laptop to my Atmega16. For this purpose I am using USBASP. The datasheet for the USBASP I am using is attached below. I followed the pinout and driver installation according to the manual. However, when I try to transsfer code I get following error:
avrdude: warning: cannot set sck period. please check for usbasp firmware update.
avrdude: error: programm enable: target doesn't answer. 1
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
avrdude done. Thank you.
Assuming it is micro-controller error I bought a new IC but the problem persist. Please let me know how to proceed further
Regards
Srinidhi