Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help: Cadence error: V5: Waveform type must be specified

Status
Not open for further replies.
L

lunren

Member level 4
Joined
Jun 19, 2003
Messages
71
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,288
Activity points
661
waveform type must be

I use Cadence to work on a project, but there is a error: V5: Waveform type must be specified if any waveform parameters are given.
I searched internet, it seems that lot of people meeting this problem, but no good solutions. Anybody here can give some ideas?

Another problem is that dependent sources from analogLib can not be used. For example, when I set the gain of vcvs to 2 and extract netlist, the gain parameter can not be extracted. The netlist is always like this:
E1 (net1 net2 net3 net4) vcvs
The gain=2 parameter is always ignored. How to deal this problem?

Added after 2 minutes:

By the way, I installed IC5141 USR4
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top