Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

guidlines for data bus, clock and high speed signals routing

Status
Not open for further replies.
S

s3034585

Full Member level 4
Joined
May 24, 2004
Messages
226
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Activity points
2,087
hi guys

i am new to pcb routing. can anyone pls tell me some guidlines to follow while routing data bus, clock and high speed signals..... i know that data bus, differential signals, address bus have to be of same length from the point of timing... i am trying to equalize nets in altium designer. the pin out of the devices makes it bit difficult to route on the same layer. is it fine doing so...

can some one pls help me this... if some one has any info pls let me know...

thanks in advance
tama
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top