Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

GSM Output Power Levels. Please Help

Status
Not open for further replies.

somada141

Member level 1
Joined
Mar 13, 2008
Messages
34
Helped
5
Reputation
10
Reaction score
1
Trophy points
1,288
Activity points
1,610
gsm power levels

Hi everybody, I have an question regarding GSM phone power outputs.

From what I can understand a typical GSM900 phone radiates at a maximum of 2Watt and because of the TDMA usage the average maximum power level is 250mW.

For a GSM1800 phone the power levels are the half of the above (1W max and 0.125W average)

What I need to know is:

Are the above values the peak (Amplitude) values or the RMS values?

Thank you ever so much
 

gsm power

In GSM only peak power is measured.
 

    somada141

    Points: 2
    Helpful Answer Positive Rating
gsm output power

Can you PLEASE direct me to any source that validates that? A book, a paper, an article anything PLZ

My advisor insists on the RMS thing and I need hard evidence to make him change his mind...

Thanks a million
 

gsm power class

see this



and the attached file
 

    somada141

    Points: 2
    Helpful Answer Positive Rating
gsm output

Thank you for your help everyone. I think I got it now
 

gsm output power class

GSM uses GMSK so RMS power is the better sense.
How ever the power class is different from the comparison of peak and RMS
 

power output gsm

In GSM (GMSK modulation) only peak power is measured.
The power measurement is done for more than 100 bursts, and finally is done an average of the results.
 

pdf of gsm

vfone said:
In GSM (GMSK modulation) only peak power is measured.
The power measurement is done for more than 100 bursts, and finally is done an average of the results.

this is a new note for me.
thank you too much
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top