generate components in layout - advanced design system 2014

[Sarvenaz]

Hi I want to generate layout from schematic but lay out doesn't know resistor and... What can I do?and for example I have tow capacitor with tow foot prints how can I add them to layout I mean in schematic what must I do?:bang:

 

[volker@muehlhaus]

Use components from ADS palette "Lumped with artwork", or use a component library (design kit) from a manufacturer who pre-defined the SMD elements.

 

[Sarvenaz]

Ok thanks but for example the circuit has ten smd 603 capacitors how can I tell schematic that this cap is 603 ?only by l and w?or if I make a layout for 603 separately in shematic how can I tell ads that these caps in schematic is 603 to have 603 in layout

 

[volker@muehlhaus]

Ok thanks but for example the circuit has ten smd 603 capacitors how can I tell schematic that this cap is 603 ?only by l and w?

For the example that I showed, by w and l.

You can also find a manufacturer library where everything is predefined, including electrical models and layout.
https://www.murata.com/en-us/tool/library/keysight2

Good luck!