nsgil85
Member level 4
Hi Friends,
I'm facing with annoying problem that I hope you can assist.
When I try programming the FPGA (Cyclone IV) with a .sof file it works as planned.
But when i'm trying to program it with The .jic file it can't retrieve the
configuration files from the EPCQ16 chip (CONF_DONE remain LOW).
For converting the .sof file i'm using Altera's "Convert programming fle" SW
Setup :
My question is what can cause this problem? and how do i fix it?
Thanks in advance.
Gil
I'm facing with annoying problem that I hope you can assist.
When I try programming the FPGA (Cyclone IV) with a .sof file it works as planned.
But when i'm trying to program it with The .jic file it can't retrieve the
configuration files from the EPCQ16 chip (CONF_DONE remain LOW).
For converting the .sof file i'm using Altera's "Convert programming fle" SW
Setup :
- "Disable EPCS/EPCQ ID check" - Unchecked
- "Disable AS mode CONF_DONE error check" - Checked
My question is what can cause this problem? and how do i fix it?
Thanks in advance.
Gil