Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Feed-line width and length- microstrip patch

Status
Not open for further replies.

Vagish Rajan

Newbie level 5
Newbie level 5
Joined
Apr 1, 2013
Messages
9
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,337
Hi,
Could anyone give the formula to calculate the feed width and length of an inset fed microstrip patch antenna?
The design is being done using HFSS software.
Solution freq. is 2.4GHz
Substrate- FR4 Epoxy fig.png
With reference to the fig, I need the value of W and the feed length
 
For ur antenna, I calculated the parameters with Ansoft designer. Hope the figure helps..
Secondly u can download alot of IEEE papers for formulas and google Microwave books on this subject.

Inset patch.jpg
 
Thank you.
If it's not too much trouble for you, can u send me a few links to IEEE papers as I could not find any.
And u have directly given the values as calculated by Ansoft HFSS ADK.
But I need the formulae/rule to theoretically calculate it.
 

Thanks a lot.
It was very helpful.
But I find that there is no solid formula for the feed line width.
Even in the documents u provided links for.
Thank you again! :smile:
 

I got the formula for calculating the width of printed transmission line when I stumbled upon a book called "Antenna Engineering Handbook" by Volakis
Thank you again.:smile:
 

Good to know and best of luck.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top