Depp
Member level 3
cadence libinit.il
Hi every one,
I installed the chrt18rf_sige_Rev2.1a_062405.tar from pdk.cadence.com.
but when I try to open an testcase schematic which includes only a MOS symbol from chrt18base and a MOS symbol from chrt18rf ,then the failure appears in the cds.log as follows:
......
\\o failed!
\o Failed to load chrt18base/libInit.il successfully!Loading chrt18rf/libInit.il ...
\o Loading context 'chrt18rf' from library 'chrt18rf' ... done!
\o Loading chrt18rf/.cdsenv ... done!
\e Loading chrt18rf/libInitCustomExit.il ... *Error* asiiInitializeTool: Tool `UltraSim' has not been registered
\e
\a hiResizeWindow(window(1) list(155:-28 880:133))
\r t
\e *Error* asiiInitializeTool: Unable to initialize tool `UltraSim'
\e
\a hiResizeWindow(window(1) list(155:-28 880:133))
\r t
\e *Error* No method supplied for generic function asiEnvGetVar
\e
\o failed!
\o Failed to load chrt18rf/libInit.il successfully!Loading schematic.cxt
......
does this failure caused by the unregistered tool of "UltraSim"?
or there are some wrong in the "chrt18base/libInit.il" and "chrt18rf/libInit.il" ?
i'm using ic5141 base under rhel4.
thank you.
Added after 4 hours 7 minutes:
does ic5141 include the tool of ultrasim ???
thank you.
Hi every one,
I installed the chrt18rf_sige_Rev2.1a_062405.tar from pdk.cadence.com.
but when I try to open an testcase schematic which includes only a MOS symbol from chrt18base and a MOS symbol from chrt18rf ,then the failure appears in the cds.log as follows:
......
\\o failed!
\o Failed to load chrt18base/libInit.il successfully!Loading chrt18rf/libInit.il ...
\o Loading context 'chrt18rf' from library 'chrt18rf' ... done!
\o Loading chrt18rf/.cdsenv ... done!
\e Loading chrt18rf/libInitCustomExit.il ... *Error* asiiInitializeTool: Tool `UltraSim' has not been registered
\e
\a hiResizeWindow(window(1) list(155:-28 880:133))
\r t
\e *Error* asiiInitializeTool: Unable to initialize tool `UltraSim'
\e
\a hiResizeWindow(window(1) list(155:-28 880:133))
\r t
\e *Error* No method supplied for generic function asiEnvGetVar
\e
\o failed!
\o Failed to load chrt18rf/libInit.il successfully!Loading schematic.cxt
......
does this failure caused by the unregistered tool of "UltraSim"?
or there are some wrong in the "chrt18base/libInit.il" and "chrt18rf/libInit.il" ?
i'm using ic5141 base under rhel4.
thank you.
Added after 4 hours 7 minutes:
does ic5141 include the tool of ultrasim ???
thank you.