pixiemouse
Newbie level 4
Hi,
I am new to CST as well as PCB milling. I tried exporting a antenna simulation from CST as a gerber file. ISOPRO does not register the aperture list for some reason. All it shows is D999 with 0 width.
I also tried to view the gerber file using McCAD. Again McCAD shows an empty aperture table. Any ideas why this is happening.
Really appreciate your help.
Thanks
I am new to CST as well as PCB milling. I tried exporting a antenna simulation from CST as a gerber file. ISOPRO does not register the aperture list for some reason. All it shows is D999 with 0 width.
I also tried to view the gerber file using McCAD. Again McCAD shows an empty aperture table. Any ideas why this is happening.
Really appreciate your help.
Thanks