rkmuchandikar
Newbie level 4
i m trying to send esc commmand sequence to thermal printer using hyper terminal
but i dnt know which format i sholud used
eg,
ESC % n this is 1 command as per module which will print data using different font ..but whenever i send this command printer simply print this command as it is(ESC % n). it should not print this command it should accept command as shld change font.
plz help me
but i dnt know which format i sholud used
eg,
ESC % n this is 1 command as per module which will print data using different font ..but whenever i send this command printer simply print this command as it is(ESC % n). it should not print this command it should accept command as shld change font.
plz help me