ankit rajput
Newbie level 6
Hi
I am trying to do hardware software co-simulation using ZCU 102 zynq ultrascale board. I am able to generate hardware software co-sim block as shown below:
**broken link removed**
but when I add add this block to simulink and try to run i get the following error:
**broken link removed**
I find out that part number of zcu102 board shown in system generator token and hwcosim block has a difference of one alphabet , shown in below images:
**broken link removed**
**broken link removed**
Is this a reason for error?
how to solve that?
thanks
I am trying to do hardware software co-simulation using ZCU 102 zynq ultrascale board. I am able to generate hardware software co-sim block as shown below:
**broken link removed**
but when I add add this block to simulink and try to run i get the following error:
**broken link removed**
I find out that part number of zcu102 board shown in system generator token and hwcosim block has a difference of one alphabet , shown in below images:
**broken link removed**
**broken link removed**
Is this a reason for error?
how to solve that?
thanks