Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Drive and Slew Rate for SDRAM and other devices??

Status
Not open for further replies.

paviljonac

Junior Member level 1
Junior Member level 1
Joined
Feb 28, 2004
Messages
17
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,281
Activity points
152
slew rate + drive strength

hi,

fast slew rate is not ALWAYS better than slow slew rate. fast transitions can cause undesired reflection. on the other hand, by limiting drive strength one can avoid ground bouncing. this issue is critical when rating buses.
 

    davyzhu

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top