Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Drill machine problem

Status
Not open for further replies.
S

smiles

Advanced Member level 4
Joined
Jul 27, 2007
Messages
110
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,096
220V power supply, and when it fed to that device, I see that the fan in PSU circuit run well, but when I press the button to start the drill then it rotates for a while and stop, the fan is too.
Try again and this phenomenon repeats, I know when I press the button to start the drill, the current pass by fan is descrease but why the drill stop, where in the circuit should I check first ? (see no exploded places)
Thanks !!!
 

Dear Sir. Your power supply can't produce enough amps to keep the drill going. Regards :cry:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top