Does Kicad support for Micro blind via

[arunmaran10]

Hi All,
Does Kicad support for Micro blind via?
Say i am using micro vias of 10mill pad and hole 4mil. I can route on the 1-2 or 6-5 for 6-layer board. But inner layers it is not supporting(2-3,3-4.4-5). Please suggest some solution.]


Regards,
Arunmaran

 

[marce]

As most modern day SMD footprints are hard metric and as mm is a standard unit why not work in metric, its a lot better.


For inner layers a conventionally drilled via is used or stacked microvias, read this:

https://www.we-online.com/web/en/in...hdi/02072013_Webinar_HDI_DesignGuide_1_EN.pdf