Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Develop Multifunction Calibrator

Status
Not open for further replies.
P

pany2008

Junior Member level 3
Joined
Aug 24, 2009
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
India
Activity points
1,627
Hi all,

I want to make Multifunction Calibrator for my personal use.

Specification for Calibrator (Measure and Generate both) :-
1) mili Volt Range :- 0 to 100 mv
2) mili Amp Range :- 0 to 24 mA
3) Volt Range :- 0 to 30VDC
4) RTD Sensor
5) Thermocouple Sensor

Calibrator will operate with 4.7V battery.

Looking for Analog Section Schematic, ADC schematic.

If any one can help out in any small part also wellcome.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top