Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Design Fully Differential Opamp

Status
Not open for further replies.

shaq

Full Member level 5
Full Member level 5
Joined
Jul 23, 2005
Messages
311
Helped
14
Reputation
28
Reaction score
4
Trophy points
1,298
Activity points
3,397
fully differential class ab output stage

Dear all,

Here is my specification.

Process: TSMC 0.18µm

Voltage: 1.8v

DC gain: ≥70dB

UGBW: ≥55MHz

Slew Rate:≥45V/µs

Phase Margin:≥60°

Can anyone give some suggestions ?
 

fully differencial opamp tutorial

gain boast+cascode
 

dr. vadim ivanov op amp

sunking said:
gain boast+cascode

How about if I use folded differential opamp + cmfb?
 

It should be okay for fold cascode.
 

u can use foldedcascode 1 stage architecture.gainboostig is the must.for optimizing speed,current must equal in input & cascod devices.
 

I think one-stage folded-cascode is enough,
but you nedd take care to SR
so the tail current may be large
hehe
 

Do u have a linearity spec??
 

Go for folded cascode for achieving these specs
Can we have the power specs as well to be more
accurate ?
 

please provide tutorial to design Folded cascode opamp, or suggest some book or papers..

thank you
 
i don't know the load capacitor's value
if it's large, maybe you can use the class AB output stage, and the first stage is folded-cascode amplifier
for the class AB output stage, Vadim V. Ivanov and J. Baker's book refer to it respectively
good luck
 

Dear Sir/Madam

Since 70dB gain can be achieved with one stage opamp you don't need to use cascading which introduce complex compensation but you can use a simple telescopic cascode with fully differential boosters, remember you have to use CMFB for your opamp and also boosters if they are fully differential. Good luck
 

shaq said:
Dear all,

Here is my specification.

Process: TSMC 0.18µm

Voltage: 1.8v

DC gain: ≥70dB

UGBW: ≥55MHz

Slew Rate:≥45V/µs

Phase Margin:≥60°

Can anyone give some suggestions ?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top