Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I am new member in analog design session. I am designing op-amp two-stages. I have a question: when i run DC analysis, I have a DC response showing in attached picture below:
What information can I extract form this DC response? Vout max, min, voltage output swing, Slew rate?
Many thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.