Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

creating output file for printout

Status
Not open for further replies.

m_kavith

Member level 3
Member level 3
Joined
Jun 14, 2010
Messages
58
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
chennai
Activity points
1,638
i created output using gerbertool. my problem drill holes are not opened in my pdf file. drill hole chart not required but it also comes in pdf file. i want to hide it.
 

what your tool? you can open or off layer and delete drill chart with gerber tools ex. CAM350 or CAMtastic in Altium or GerberTool in OrCAD for easy print out or you can use Blueprint software for create engineering document.
 

i use layoutplus and orcad gerbertool8.1.1.if i off the DRD layer i cant centre the drawing in printout and board outline is not visible.i attached one pdf. i dont need lik this
 

File-->page setup on Outline and Drill

**broken link removed**
 

if you need to print PDF data mens use any gerber viewer like GC PREVEUE which is free... then print to PDF. In many cases I have used this technique.
 

in my pagesetup there is no center option. i need pdf lik this.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top