tech5006
Newbie level 2
I have 12v DC supply (POWER SUPPLY 1) and 230AC supply (POWER SUPPLY 2).
I need to make a system in which the “POWER SUPPLY 1” will provide the required power to the load. And if there is an overload condition, instead of switching over to the “POWER SUPPLY 2” completely,
“POWER SUPPLY 1” should provide the power by combining the excess required power from “POWER SUPPLY 2”.
It’s not equal sharing by the two supplies but “POWER SUPPLY 2” should provide the required excess power only.
I request your valuable advice and suggestions to meet the requirement. Thanks in advance...
I need to make a system in which the “POWER SUPPLY 1” will provide the required power to the load. And if there is an overload condition, instead of switching over to the “POWER SUPPLY 2” completely,
“POWER SUPPLY 1” should provide the power by combining the excess required power from “POWER SUPPLY 2”.
It’s not equal sharing by the two supplies but “POWER SUPPLY 2” should provide the required excess power only.
I request your valuable advice and suggestions to meet the requirement. Thanks in advance...