Elec. Engineer
Newbie level 5
Hello ..
i have a mini project and i need some help ..
the cirteria is as follows:
Please Read Entire Project Description!!
Please create a C program to meet the criteria.
Digital System:
A computer is used to monitor the flow rate of a liquid and the speed of the pump motor in a process control system. The computer will read the value of the speed and display the results on the computer every 5 seconds. The computer will warn the operator if the speed exceeds a specified value entered at the start of the program.
The flow rate of the system is given by the following formula.
flow rate = square_root (speed * tan(Radius/Shaft Length))
Deliverable:
Each assignment must include the Flow Chart and the C Language Code. Please include comments in your C program that explains each section and follows the standard outlined in the Example CASE STUDY in your workbook.
Program Criteria:
At the beginning of the program, the user will enter the system data.
=> Radius of Motor Rotor
=> Shaft Length
(The Radius must be less than the Length or the program will repeat the entering cycle.)
=> Maximum Motor Speed
The computer will display the input speed, the flow rate, and the time of display on the console every 5 seconds.
The computer will fill the screen with 10 lines of data. After that, the program will clear the screen and continue to display the data until another 10 lines and repeats.
The program will save the data in a log txt file “Datalog.txt” so the data can be read at a later date.
The keyboard will be used as a virtual input to the system. The speed range of values accepted by your system is between 33 rev/sec to 126 rev/sec. Refer to the ASCII table to learn how to enter these values from the keyboard. If the input exceeds the maximum value inputted by the operator, the computer will display a warning message and output a warning “beep”.
[/GVideo]\]
i have a mini project and i need some help ..
the cirteria is as follows:
Please Read Entire Project Description!!
Please create a C program to meet the criteria.
Digital System:
A computer is used to monitor the flow rate of a liquid and the speed of the pump motor in a process control system. The computer will read the value of the speed and display the results on the computer every 5 seconds. The computer will warn the operator if the speed exceeds a specified value entered at the start of the program.
The flow rate of the system is given by the following formula.
flow rate = square_root (speed * tan(Radius/Shaft Length))
Deliverable:
Each assignment must include the Flow Chart and the C Language Code. Please include comments in your C program that explains each section and follows the standard outlined in the Example CASE STUDY in your workbook.
Program Criteria:
At the beginning of the program, the user will enter the system data.
=> Radius of Motor Rotor
=> Shaft Length
(The Radius must be less than the Length or the program will repeat the entering cycle.)
=> Maximum Motor Speed
The computer will display the input speed, the flow rate, and the time of display on the console every 5 seconds.
The computer will fill the screen with 10 lines of data. After that, the program will clear the screen and continue to display the data until another 10 lines and repeats.
The program will save the data in a log txt file “Datalog.txt” so the data can be read at a later date.
The keyboard will be used as a virtual input to the system. The speed range of values accepted by your system is between 33 rev/sec to 126 rev/sec. Refer to the ASCII table to learn how to enter these values from the keyboard. If the input exceeds the maximum value inputted by the operator, the computer will display a warning message and output a warning “beep”.
[/GVideo]\]