prmurthy
Full Member level 5
Hi all,
I know this question is not new in this board. But I could not find the correct solution.
Q. Can we applied PWM signal to MOC(any non-zero cross).The other side of the MOC is connected to a AC Heater, how much AC voltage is not the concern?
Basically the idea is to control the heater heat level.
Thanks
I know this question is not new in this board. But I could not find the correct solution.
Q. Can we applied PWM signal to MOC(any non-zero cross).The other side of the MOC is connected to a AC Heater, how much AC voltage is not the concern?
Basically the idea is to control the heater heat level.
Thanks