Elhb
Newbie level 3
Hi,
In my project , I need to adapt an FPGA card to read data from 4 CAN network at least. Beacuse i didn't found an FPGA including more than 2 CAN controllers. i ´m wondering if there is a solution for this. I read that is possible to emumate CAN bus with RX TX I/O of the fpga with an IP core but i dont't find more information of how it is possible.
Also , i don't know if we can use the protocole CAN only with the GPIO of the fpga.
Can any of you guys suggest how to perform this ?
thx..
In my project , I need to adapt an FPGA card to read data from 4 CAN network at least. Beacuse i didn't found an FPGA including more than 2 CAN controllers. i ´m wondering if there is a solution for this. I read that is possible to emumate CAN bus with RX TX I/O of the fpga with an IP core but i dont't find more information of how it is possible.
Also , i don't know if we can use the protocole CAN only with the GPIO of the fpga.
Can any of you guys suggest how to perform this ?
thx..