Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can integration line be parameterize?

Status
Not open for further replies.
J

jslee

Junior Member level 1
Joined
Nov 19, 2005
Messages
19
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,488
Hello:
I am simulating a CPW for a 50Ohm chracteristic impedance. I sweep gap between signal line and ground line. However, as I sweep gap, the integration line doesn't change with gap so that the simulation is wrong. My question is that may we parametrize the integration coordinates ?
Thank you very much.
Best Regards, Chun-Hsing
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top