Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can Cadence Nanoroute forbid bends on one routing layer?

Status
Not open for further replies.
F

fallfly

Newbie level 1
Joined
Mar 4, 2011
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,285
I use cadence nanoroute to do the routing, and I wanna metal 2 all vertical. Is there any commands to do this?
 

they should be option to set metal orientation. or try to find option that enable metal route jog.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top