Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

caculation of quarter wave transformer in microstrip antenna

Status
Not open for further replies.

ljx1067

Junior Member level 1
Junior Member level 1
Joined
Mar 30, 2008
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,382
microstrip quarter-wave length transformer

in the attached paper, the frequency is 6GHz,but the transformer is 4.922mm long,not lambda/4 at all. why is that?
And in caculating the resistance Zin of patch, I get G1=0.0025, G12=0.0042,it seems not a right result!

thanks!
 

quarter wave transformer for antenna

Electrical length of a transmission line may be different than the Physical length.
 

Re: caculation of quarter wave transformer in microstrip ant

well i think quarter wave transformer length is close to lambda/4.

as the substrate permitivity is 4.4 so the guided wavelength is 24mm approx.

so lambda/4=5.9

so the optmized length for this design may be 4.9

i hope this answers your question
 

Re: caculation of quarter wave transformer in microstrip ant

Dear ljx1067

you need to know that in papers the author not allays give you the exact
design. he gives you the start of his work and the end of it and then let you to figure what is missing between.
about the λ/4 the coupling between the patch and transformer also radiation from patch and thin line
cause to the change in dimantion.

pl
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top