jayanthyk192
Full Member level 3
hi,
i just bought an AT89C51 along with a readymade development board.first i used a P89C51RD2 with the board to conform that the board was working.(i had a burner for this IC).then i used the atmel chip.i did'nt have a burner so i downloaded 2 burners.but both of them did'nt detect the chip.
does it require some kind of a bootloader?i'm sure the board is proper and so is the ic,because i bought 2 and both of them were not detected.
please help.thank you
i just bought an AT89C51 along with a readymade development board.first i used a P89C51RD2 with the board to conform that the board was working.(i had a burner for this IC).then i used the atmel chip.i did'nt have a burner so i downloaded 2 burners.but both of them did'nt detect the chip.
does it require some kind of a bootloader?i'm sure the board is proper and so is the ic,because i bought 2 and both of them were not detected.
please help.thank you