Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

breadboard/protoboard construction.

Status
Not open for further replies.
T

teqno

Newbie level 2
Joined
Sep 19, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
durban
Activity points
1,309
how can i connect up a full-adder on a breadboard using only AND,OR and NOT gates? im requiered to use the equivalent circuit for the ex-clusive OR gete. how can i go about constructing a circuit in that manner?
 

Hi,

It is very easy to construct. take the IC for AND , OR and NOT .. Refer the pin diagram for input and output. Fix the ICs in the Bread board (Know the bread board connection before). Based on the diagram connect the pins by using wires. Give the input (5V=logic high and 0=logic low) and heck the output in the corresponding output pins.

Sudan
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top