bert_kak
Member level 5
- Joined
- Aug 24, 2009
- Messages
- 87
- Helped
- 19
- Reputation
- 38
- Reaction score
- 16
- Trophy points
- 1,288
- Location
- Philippines
- Activity points
- 1,829
I'm new in using Blind and Buried VIA. Can someone help me on how to setup blind and buried via in PCAD2006.
I've tried configuring settings in these commands but i'm not sure if i'm correct.
- Via Styles (Modify Complex), Modify Hole Range
Can you give me example?
Also, can you help me on how to set up N/C Drill Files and set up drill table for fabrication. Thank you.
I've tried configuring settings in these commands but i'm not sure if i'm correct.
- Via Styles (Modify Complex), Modify Hole Range
Can you give me example?
Also, can you help me on how to set up N/C Drill Files and set up drill table for fabrication. Thank you.