avins_1234
Member level 3
Hello,
I am simulating a design - this is for matlab VSS co-simulation.
I have used two saw tooth blocks and connected them to matlab block in VSS. When I run this, I get the message.
Executing STARTCMD: Attempt to reference field of non-structure array.
The schematic is as shown.
The matlab graph window opens, but does not show any thing.
Regards,
Avs
I am simulating a design - this is for matlab VSS co-simulation.
I have used two saw tooth blocks and connected them to matlab block in VSS. When I run this, I get the message.
Executing STARTCMD: Attempt to reference field of non-structure array.
The schematic is as shown.
The matlab graph window opens, but does not show any thing.
Regards,
Avs