Rocketman46
Member level 3
Hi all,
I am using Atmel Studio 6.2 with the Atmel ICE and I have made the mistake of unseleting the JTAGEN tick box. Anyway I programmed the MCU and I have lost all communication with the MCU now.
I have build another board and completed the below steps, but I am still having problems communication with the MCU:
Rebuild Solution >> Device Programming >> Apply >> Fuses, and "unable to program" is shown. I have not programmed the MCU yet to blow the JTAGEN on the new chip. How do I set Device Programming back to defaults?
Is it a setting in the programmer Atmel ICE that has blow, because I would of thought the new board and MCU with of sorted my JTAGEN issues?
Look forward to your reply.
I am using Atmel Studio 6.2 with the Atmel ICE and I have made the mistake of unseleting the JTAGEN tick box. Anyway I programmed the MCU and I have lost all communication with the MCU now.
I have build another board and completed the below steps, but I am still having problems communication with the MCU:
Rebuild Solution >> Device Programming >> Apply >> Fuses, and "unable to program" is shown. I have not programmed the MCU yet to blow the JTAGEN on the new chip. How do I set Device Programming back to defaults?
Is it a setting in the programmer Atmel ICE that has blow, because I would of thought the new board and MCU with of sorted my JTAGEN issues?
Look forward to your reply.