Maverickmax
Advanced Member level 1
auto segment too large
Hi
I have been learning to use 128x64 LCD module with AT89C51 and I have been using FastLCD for converting bmp into a table of bytes.
I have use the table in my codes and tried to compile it uisng the Keil software. I get the result - auto segment too large.
How to put all bytes in my codes in order to display picture on my 128x64 LCD module.
I don't understand it. What is the problem?
Maverick Max
Added after 17 minutes:
I found the information about error but I don't understand. Can someone care to explain it to me?
Error C241
Summary
*** Error C241
Auto Segment Too Large
Description The required space for local objects exceeds the model dependent maximum. The maximum segment sizes are defined as follows: SMALL 128 bytes COMPACT 256 bytes LARGE 65535 bytes
https://www.keil.com/support/man/docs/c51/c51_c241.htm
Does this mean that the codes is too way too big for my microcontroller?
Maverick Max
Hi
I have been learning to use 128x64 LCD module with AT89C51 and I have been using FastLCD for converting bmp into a table of bytes.
I have use the table in my codes and tried to compile it uisng the Keil software. I get the result - auto segment too large.
How to put all bytes in my codes in order to display picture on my 128x64 LCD module.
I don't understand it. What is the problem?
Maverick Max
Added after 17 minutes:
I found the information about error but I don't understand. Can someone care to explain it to me?
Error C241
Summary
*** Error C241
Auto Segment Too Large
Description The required space for local objects exceeds the model dependent maximum. The maximum segment sizes are defined as follows: SMALL 128 bytes COMPACT 256 bytes LARGE 65535 bytes
https://www.keil.com/support/man/docs/c51/c51_c241.htm
Does this mean that the codes is too way too big for my microcontroller?
Maverick Max