Paras99
Newbie level 4
VCC=12V.
I am feeding 12V into a voltage divider formed by an 200ohms resistor
and an 1K POT to vary the output of my vltg divider.
I am getting 0(some mV)-10V as per expectation at the vltg divider output.
I have further used an voltage follower ckt.
When i connect my load at vlg follower output the voltage reduces to
2V from 10V.
I want to supply 10V to the load, what should i do?
I am feeding 12V into a voltage divider formed by an 200ohms resistor
and an 1K POT to vary the output of my vltg divider.
I am getting 0(some mV)-10V as per expectation at the vltg divider output.
I have further used an voltage follower ckt.
When i connect my load at vlg follower output the voltage reduces to
2V from 10V.
I want to supply 10V to the load, what should i do?