Golden Electronics
Full Member level 5
Dear Sir,
I use ADIS16209 MEMS sensor for sensing tilt angle. I face following problem, can u suggest solution to avoid this problem.
In steady state condition sensor gives output as per change in inclination angle. When sensor with its mounting plate kept on vibration test having operating frequency range 20-60 Hz at 3 g then sensor output change due to vibration condition. As vibration tester vibrate its mounting plate in horizontal X or Y axis than why MEMS sensor output change. Is anyone facing such condition if yes than please share your experience?
How I can solve this issue is any application note or guideline than please share it.
I use ADIS16209 MEMS sensor for sensing tilt angle. I face following problem, can u suggest solution to avoid this problem.
In steady state condition sensor gives output as per change in inclination angle. When sensor with its mounting plate kept on vibration test having operating frequency range 20-60 Hz at 3 g then sensor output change due to vibration condition. As vibration tester vibrate its mounting plate in horizontal X or Y axis than why MEMS sensor output change. Is anyone facing such condition if yes than please share your experience?
How I can solve this issue is any application note or guideline than please share it.