JohnG300c
Advanced Member level 4
I can't find any way to move components / footprints to the bottom layer in Altium Designer except for double-clicking each pad in order and specifying the new layer. There surely must be a much better way to do this (shortcut meny etc)?
Ideally, i would like to use a directive already in the schematics since i already know at schematics capture time that decoupling caps etc should be on the bottom layer.
Ideally, i would like to use a directive already in the schematics since i already know at schematics capture time that decoupling caps etc should be on the bottom layer.