Beenaplaye
Member level 2
Hi guys,
Can u describe the steps to make a new component in the library.
I already made the footprint and the schematic of the component. Do I need to compile it when its finish?
Kind regards,
Jo
Added after 2 hours 49 minutes:
I made a new schematic component. But the pin names are shown outside my component.
How to put them in the component rectangle box?
regards,
Jo
Can u describe the steps to make a new component in the library.
I already made the footprint and the schematic of the component. Do I need to compile it when its finish?
Kind regards,
Jo
Added after 2 hours 49 minutes:
I made a new schematic component. But the pin names are shown outside my component.
How to put them in the component rectangle box?
regards,
Jo