policeman0077
Newbie
I am new to Altium. So might be very noob questions but I could not figure out what's the problem. I tried to use the auto stiching function and found out it could not stiching areas where has other polygons carry different signal.
So I deleted all the auto stiching vias and redo them manually. But after I do it, altium seems leaves white outlines for the restrained areas I defined for stiching vias. And I can not select those outlines or delete them.
[moderator action: removed links to external file servers]
I tried highlight stiching via union there is nothing.
[moderator action: removed links to external file servers]
Any some ghost via shows 13 count and not highlighted?
[moderator action: removed links to external file servers]
I know this might not afect anything in the design but it's just anoying
Seems we could not use external picture links here. I attached the screen shots again.
So I deleted all the auto stiching vias and redo them manually. But after I do it, altium seems leaves white outlines for the restrained areas I defined for stiching vias. And I can not select those outlines or delete them.
[moderator action: removed links to external file servers]
I tried highlight stiching via union there is nothing.
[moderator action: removed links to external file servers]
Any some ghost via shows 13 count and not highlighted?
[moderator action: removed links to external file servers]
I know this might not afect anything in the design but it's just anoying
--- Updated ---
Seems we could not use external picture links here. I attached the screen shots again.
Last edited:
