Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello Everyone;
Can we use ADS2004 for simulation of a receiver and calculation of parameters like sensitivity, IP3, 1dB compression point and noise figure?
ADS already have this capability since version 1.1. It has a Meas Eqn component located at Simulation S_Param and Simulation -HB pallete that serve that purpose, the flexibility of ADS lies on the built in Eqn and you can display it graphically in Data Display windows.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.