Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Accelerometer- ADXL335 How does it works?

Status
Not open for further replies.

rkt_167

Junior Member level 1
Junior Member level 1
Joined
Aug 9, 2013
Messages
19
Helped
3
Reputation
6
Reaction score
3
Trophy points
3
Activity points
163
can any one tell me about the working of accelerometer in short. I searched a lot on internet but got confused. I have few basic questions.

Q1. What does it gives as output angle or voltages?
e.g. I am getting the reading for three axis as x=370, y=402, z=360 What does this imply.
Q2. Is it really necessary to calibrate your accelerometer before using and if yes, then how?
 

The ADXL345 outputs voltages based on its acceleration. The outputs are not angles but in g's (1g = 9.8m/s^2).

The description of adafruit's adxl335 breakout board gives a good explanation of this accelerometer's outputs:
https://www.adafruit.com/products/163

Using a 10-bit ADC (range of 0 to 1023) with your ADC's reference voltage at VDD (let's say 3.3V) to read the ADXL335 inputs would mean:

An acceleration of -3g outputs 0V = 0 reading
At 0g (no acceleration), you would get half of VDD (1.65V) = 511 reading (half of the full 0-1023 range)
An acceleration of 3g outputs VDD (3.3V) = 1023 reading

So when you lay your accelerometer on a flat surface (not moving), it should read 0g along the x axis, 0g along the y axis, and 1g along the z axis due to gravity (1g), so you should get a reading of

x = 511
y = 511
z = 663

The 0v to 3.3v (or -3g to +3g) is scaled along the 0-1023 range. These are all "ideal" scenarios, and of course, each accelerometer is going to have slight variations with their outputs. Calibration happens more in your host controller's application code, and is based on reading the 0g values of each axis of your accelerometer. Based on your 0g readings during the calibration process, your future readings are "adjusted" to reflect the actual acceleration of your device. Here's a link which describes the calibration process more in detail: https://www.virtuabotix.com/advance...er-guide-converting-analog-readings-g-forces/
 
  • Like
Reactions: anj and rkt_167

    rkt_167

    Points: 2
    Helpful Answer Positive Rating

    anj

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top