gaom9
Full Member level 4
calibre lvs user guide
Hi,
I have a question about the LVS of Calibre.
In my design, some parameters mismatch in layout can be ignored, how can I set the Calibre to pass the LVS. For example, I want to set the match percent of the MOS1 to be 90%, how can I set it in Calibre.
Thank you!
Best regards
Hi,
I have a question about the LVS of Calibre.
In my design, some parameters mismatch in layout can be ignored, how can I set the Calibre to pass the LVS. For example, I want to set the match percent of the MOS1 to be 90%, how can I set it in Calibre.
Thank you!
Best regards