Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A printout of 20 pin DIP does not match the part in KICAD

Status
Not open for further replies.
N

node

Newbie level 5
Joined
Jan 25, 2005
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
97
KICAD

Is anyone using KICAD and can help. I found if you were to printout the 20 pin Dip at scale 1, 1.4 or 2 it does not match the actual part.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top