Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

8051 out put pin frequency

Status
Not open for further replies.

getavinks@gmail.com

Member level 1
Member level 1
Joined
Jun 5, 2012
Messages
39
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Activity points
1,473
hello, i am using atmel 8051 with 11.0592 mhz crystal.
what will be the frequency when i make a pin high- low;

P1.0 = 1 ;
p1.0 = 0 ;

what will the frequency of p1.0 pin?
 

hello, i am using atmel 8051 with 11.0592 mhz crystal.
what will be the frequency when i make a pin high- low;

P1.0 = 1 ;
p1.0 = 0 ;

what will the frequency of p1.0 pin?

If you used 12MHz crystal the max frequency would be around 500kHz, with 11MHz it will be roughly 11/12 of that estimation ..
:wink:
IanP
 
  • Like
Reactions: DrWhoF

    DrWhoF

    Points: 2
    Helpful Answer Positive Rating
If you used 12MHz crystal the max frequency would be around 500kHz, with 11MHz it will be roughly 11/12 of that estimation ..
:wink:
IanP


Thanks for your response.

How to calculate this frequency?
 

Thanks for your response.

How to calculate this frequency?

The original 8051 core runs at 12 clock cycles per machine cycle, with most instructions executing in one or two machine cycles.
So, one machine cycle takes 1 micro-sec if the 8051 is operating from a 12 MHz clock.
SET and CLR istructions are executed in one machine cycle.

1us+1us=2us ====> f=500kHz

:wink:
IanP
 
  • Like
Reactions: DrWhoF

    DrWhoF

    Points: 2
    Helpful Answer Positive Rating
Execution time

The time needed to execute any particular instruction is determined by the formula
instruction_time.png


T is equal to C times 12 divides F

C is the number of cycles to execute the program

F is the frequency of the crystal
 
  • Like
Reactions: DrWhoF

    DrWhoF

    Points: 2
    Helpful Answer Positive Rating
see 8051 has a DIVIDE by 12 circuit built inside. So first of all divid ur clk freq by 12 and then inverse gives execution time for each cycle.

12MHz/12 = 1MHz

Execution time = 1/1MHz = 1uS

so it will take 1uS for setting bit and then 1uS for reset bit

Hence 2uS

Hence frq = 1/2uS = 500kHz


HOPE IT HELPED !!!
 
Thanks it was help full
see 8051 has a DIVIDE by 12 circuit built inside. So first of all divid ur clk freq by 12 and then inverse gives execution time for each cycle.

12MHz/12 = 1MHz

Execution time = 1/1MHz = 1uS

so it will take 1uS for setting bit and then 1uS for reset bit

Hence 2uS

Hence frq = 1/2uS = 500kHz


HOPE IT HELPED !!!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top