obrien135
Full Member level 5
- Joined
- Nov 10, 2009
- Messages
- 240
- Helped
- 5
- Reputation
- 10
- Reaction score
- 5
- Trophy points
- 1,298
- Location
- Connecticut
- Activity points
- 3,259
When building a 40M HAM rig with internal frequencies of 3MHz and 10MHz, what kind of cable should I use to connect the oscillator circuit boards to the main board (with the IF amps and mixers) and the output to the chassis mount connector and such? I've seen a type of small coax that isi used to connect signals between bpards and even across tha same board, but I don't know what to call it by name.
George
Added after 1 hours 12 minutes:
This is me again. Maybe it's shielded twisted pair I'm thinking of. Would that work?
George
Added after 1 hours 12 minutes:
This is me again. Maybe it's shielded twisted pair I'm thinking of. Would that work?