popoyboys
Advanced Member level 4
pads layout connectivity problem
i have done a layout in another pcb layout software and exported it into DXF file.
then, imported the DXF file into PADS but the routes/traces became 2D lines..
is there a way to change the Properties of those 2D lines into Route/Trace in PADS 2005?
i have done a layout in another pcb layout software and exported it into DXF file.
then, imported the DXF file into PADS but the routes/traces became 2D lines..
is there a way to change the Properties of those 2D lines into Route/Trace in PADS 2005?