Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

230VAC operated Exhaust Fan Speed Control method

Status
Not open for further replies.

Golden Electronics

Full Member level 5
Full Member level 5
Joined
May 31, 2013
Messages
308
Helped
50
Reputation
100
Reaction score
47
Trophy points
1,318
Location
India
Activity points
2,730
Dear Member,

I Require Exhaust Fan with following specification.
1. Speed control using external regulator or control
2. Operate on 230 VAC, 50 Hz
3. Size 9" or 12 "
4. application : Industrial Curing System
If u know any supplier or any solution please share
 

I wanted to control speed of a fan attached to our wood stove. I purchased a triac at Radio Shack. I constructed a circuit following the schematic. Very low cost. It worked.

I believe the fan was a 'squirrel cage' type. 120 VAC.
It drew little power so I did not need to put heat sinking on the triac.
 

I could suggest you this brand/models (Vario 9" or 12"):

**broken link removed**

They also make some external speed controllers:

**broken link removed**

I'm using some of their products (good quality stuff). You could surf their website for reference only - I'm sure there's other similar brands out there.

- - - Updated - - -

PS: Or are you looking for DIY solutions?
 

thanks for all reply. I use this in my one Industrial project. In which Fan use for air circulation cont. 24x7
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top