Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm sure Compiler's website has a lot of templates to deal either with LCD and UART reception ( not to mention here on this forum ), did you even search there ? I'm not too motivated to write line by line here along with you. If you're not able to do that, it's time to learn a few more, not to code yet.
Try to devide Projects in Tasks.
First, Complete RFID Task where you are going to use UART so your half work will finish there.
Then in program only at a time you can call two device together.
I hope this advice help you lot.
All the best
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
