Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can Usart mode be used with the I2C mode in the 16F PICs?

Status
Not open for further replies.
O

Ogive

Junior Member level 2
Joined
Mar 27, 2007
Messages
20
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,397
Hi

I am interested in using two buses in my design: one I2C and the other Usart. I know that the SPI can't be used in parallel with the I2C- Its obvious as it uses the same pins... but what about Usart? The pics in question are the 16f876a.

Thanks in advance.
 

Re: Can Usart mode be used with the I2C mode in the 16F PICs

Thanks
 

Re: Can Usart mode be used with the I2C mode in the 16F PICs

You can share the two pins between two protocols (I2C,SPI). You should use a kind of
Analog Multiplex (take care, I2C Receiver sends Acknowledge in DATA line).
**broken link removed**

Analog Multiplex by principle is bidirectional (Switchs).

Not Tri-state.

Like Pass-Gates (PMOS&NMOS in parallel)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top