Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to change voltage source to DC in OrCAD?

Status
Not open for further replies.
T

Tom2

Full Member level 5
Joined
Nov 11, 2006
Messages
318
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Activity points
3,457
I want to use a voltage source for supply but when i found only ac voltage source.What i must to change to have DC voltage??
 

orcad_problem

If you want to use for PSpice simulation in OrCAD, use a bridge network circuit based on 1n4001/1N4007 and connect to DC point.

Try to keep the offset as 0V or specified voltage inorder to get exact DC in simulation.

..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top