Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me build the port of monopole on PCB in HFSS

Status
Not open for further replies.
W

winglj

Full Member level 4
Joined
Feb 21, 2005
Messages
195
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
3,063
port of monopole on PCB

Hi, I have a question about how to build the port of a monopole on PCB in HFSS. Because in measurement, I two slots on the corner of single layer PCB to make a signal patch. And then I connect the coaxial cable on the ground of PCB and solder the inner metal to the signal patch. Finally, I also soldered one copper wire on the signal patch. How do I build it on the HFSS?
The attached picture is the structure.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top